+91 - 8141691887
   je@jeeyvee.com

Furnace - Tublar Type

INTRODUCTION
JEEYVEE Digital Bacteriological Incubator – Microprocessor Based PID Control is specifically design to cater the needs in Laboratory, Chemicals, Quality Control, R & D & Analytical, Pathological & Bacteriological Test etc. etc.
SALIENT FEATURES
  • Portable & Light Weight.
  • Cerwool Insulation.
  • Sensitive temperature sensor.
  • Bright LED Display.
  • Kanthal A-1 heating coil.
  • Easy operation and maintenance.
  • Front bottom control panel.
  • Powder coated paint.
  • Fast temperature attainment.
  • Power saving low wattage heaters.
  • APPLICATION
  • Laboratory.
  • R & D.
  • Analytical.
  • Process.
  • Annealing.
  • Chemical.
  • Metallurgical.
  • Calibration
  • And Other Research application.
  • CONSTRUCTION
    “JEEYVEE” Laboratory Tubular Furnace is having double chamber construction. Inner chamber is a high Alumina Ceramic tube and outer Mild Steel. Both the end of the furnace is covered by synthania machine sheets.
    Cerwool insulation is provided to minimize heat loss. Specially designed heater coil surrounded on outer side of ceramic tube. The Tubular Furnace will generate and transfer the heat very fast with minimum heat loss and thus maximum temperature of 850/900 Deg. C can be achieved within less than an hour. Thus the system is power consumption saver.
    CONTROL PANEL
    The control panel consisting of
  • Mains Switch.
  • Mains Indicator.
  • Digital Control System.
  • Heater ON/OFF Indication.

  • INCUBATORS AS PER CUSTOMER’S SPECIFICATION/DESIGN & SIZE CAN BE MFD
    The front of the furnace is also provided with high temperature resistive syndhania sheet.
    TECHNICAL SPECIFICATION
    TEMPERATURE RANGE Ambient to 850/900 Deg. C.
    TEMPERATURE DISPLAY 4 Digit LED.
    TEMPERATURE CONTROL Various type of Digital Controllers. Please refer the block “CONTROL SYSTEM” below.
    CONTROL ACCURACY +/-2% or better depend on types of Control Systems.
    SENSORS Cr/Al (K) Type.
    POWER SUPPLY 230 Volts Single Phase AC.
    # Mains ON/OFF Switch.
    # Mains Indicator.
    # Digital Temperature Indicator cum Controller (Microprocessor PID Control)
    # Heater ON/OFF Indicator.
    # A-Meter.
    AVAILABLE IN FOLLOWING SIZES & CONTROL SYSTEMS
    S I Z E S CONTROL SYSTEM BY….
    ID MM OD MM LENGTH OF FURNACE MICRO-CONTROL MODEL PID CONTROL MODEL PROG. CONTROL MODEL
    55/60 140 300mm Accu.+/-3%FSD Accu.+/-1.5%
    FSD or better
    Accu.+/-1.5% FSD or better
    38 to 40 100-120 300mm +/-1 Deg. C    
    NOTE
    Tubular Furnace as per Customers Specification, Design/Application, Temperature Range and Size can be Manufacturing.